Fabrication and Characterization of Nanostructure Functionally Graded Ni-P Electroless Coating

Subject Areas : Surface Engineering

Sayede Razieh Anvari ¹ ( Young Researchers and Elite Club, Najafabad Branch, Islamic Azad University, Najafabad, Iran )
Sayed Mahmoud Monirvaghefi ² ( Department of Materials Engineering, Isfahan University of Technology, Isfahan, Iran )
Mohammad Hossein Enayati ³ ( Department of Materials Engineering, Isfahan University of Technology, Isfahan, Iran )

Received: 2016-01-22 Accepted : 2016-03-01 Published : 2016-03-01

Keywords:

References:

[1]    A. Zarebidaki and S. R. Allahkaram, “Porosity measurement of electroless Ni–P coatings reinforced by CNT or SiC particles,” Surf. Eng., vol. 28, pp. 400–405, 2012.

[2]    C. L. Ban, X. Shao, and L. P. Wang, “Ultrasonic irradiation assisted electroless Ni–P coating on magnesium alloy,” Surf. Eng., vol. 30, pp. 880–885, 2014.

[3]    M. H. Sadhir, M. Saranya, M. Aravind, A. Srinivasan, A. Siddharthan, and N. Rajendran, “Comparison of in situ and ex situ reduced graphene oxide reinforced electroless nickel phosphorus nanocomposite coating,” Appl. Surf. Sci., vol. 320, pp. 171–176, 2014.

[4]    S. Alirezaei, S. M. Monirvaghefi, A. Saatchi, and A. Motallebzadeh, “High temperature tribology of nanocrystalline Ni – P – Ag coating,” Surf. Eng., vol. 29, no. 4, pp. 306–311, 2013.

[5]    L. L. Wang, H. J. Chen, and Z. L. Chen, “Study on post‐treatments for electroless Ni–P coating,” Surf. Eng., vol. 27, pp. 57–60, 2011.

[6]    S. H. Park and D. N. Lee, “A study on the microstructure and phase transformation of electroless nickel deposits,” J. Mater. Sci., vol. 23, no. 5, pp. 1643–1654, 1988.

[7]    A. W. Goldstein, W. Rostoker, and J. J. Rezek, “Electron microscope study of the nucleation and growth of electroless cobalt and nickel,” J. Electrochem. Soc., vol. 119, pp. 1614–1619, 1972.

[8]    E. Vafaei-Makhsoos, E. L. Thomas, and E. L. Toth, “Electron microscopy of crystalline and amorphous Ni-P electrodeposited films: in-situ crystallization of an amorphous solid,” Metall. Trans. A, vol. 9, pp. 1449–1460, 1978.

[9]    B. Jiang, L. Xiao, S. Hu, J. Peng, H. Zhang, and M. Wang, “Optimization and kinetics of electroless Ni–P–B plating of quartz optical fiber,” Opt. Mater., vol. 31, no. 10, pp. 1532–1539, 2009.

[10]     R. Taheri, “Evaluation of Electroless Nickel-Phosphorus ( EN ) Coatings,” PhD Thesis, no. August 2002, 2003.

[11]     R. K. Upadhyay and L. A. Kumaraswamidhas, “Surface modification by multilayered W/W2N coating,” Surf. Eng., vol. 30, pp. 475–482, 2014.

[12]     F. Gao, Q. Yang, R. Liu, and X. Huang, “Oxidation resistance of novel multilayer coatings for gas turbine components,” Surf. Eng., vol. 30, no. 9, pp. 624–635, 2014.

[13]     N. E. Beliardouh, K. Bouzid, C. Nouveau, B. Tlili, and M. J. Walock, “Tribological and electrochemical performances of Cr/CrN and Cr/CrN/CrAlN multilayer coatings deposited by RF magnetron sputtering,” Trib. Inter., vol. 82, pp. 443–452, 2015.

[14]     M. A. Al-Bukhaiti, K. A. Al-hatab, W. Tillmann, F. Hoffmann, and T. Sprute, “Tribological and mechanical properties of Ti/TiAlN/TiAlCN nanoscale multilayer PVD coatings deposited on AISI H11 hot work tool steel,” Appl. Surf. Sci., vol. 318, pp. 180–190, 2014.

[15]     Ö. Baran, F. Bidev, H. Çiçek, L. Kara, İ. Efeoğlu, and T. Küçükömeroğlu, “Investigation of the friction and wear properties of Ti/TiB2/MoS2 graded-composite coatings deposited by CFUBMS under air and vacuum conditions,” Surf. Coat. Technol., vol. 260, pp. 310–315, 2014.

[16]     S. Foppiano, S. J. Marshall, E. Saiz, A. P. Tomsia, and G. W. Marshall, “Functionally graded bioactive coatings: Reproducibility and stability of the coating under cell culture conditions,” Acta Biomater., vol. 2, no. 2, pp. 133–142, 2006.

[17]     T. S. N. S. Narayanan, I. Baskaran, K. Krishnaveni, and S. Parthiban, “Deposition of electroless Ni – P graded coatings and evaluation of their corrosion resistance,” Surf. Coat. Technol. vol. 200, pp. 3438–3445, 2006.

[18]     W. X. Zhang, Z. H. Jiang, G. Y. Li, Q. Jiang, and J. S. Lian, “Electroless Ni-P / Ni-B duplex coatings for improving the hardness and the corrosion resistance of AZ91D magnesium alloy,” Appl. Surf. Sci., vol. 254, pp. 4949–4955, 2008.

[19]     T. S. N. S. Narayanan, K. Krishnaveni, and S. K. Seshadri, “Electroless Ni-P/Ni-B duplex coatings: Preparation and evaluation of microhardness, wear and corrosion resistance,” Mater. Chem. Phys., vol. 82, no. 3, pp. 771–779, 2003.

[20]     G. K. Williamson and W. H. Hall, “X-ray line broadening from filed aluminium and wolfram,” Acta Metall., vol. 1, p. 22, 1953.

[21]     D. T. Gawne and U. Ma, “Engineering properties of chromium plating and electroless and electroplated nickel,” surf. eng., vol. 4, pp. 239–249, 1988.

[22]     A. Leyland and  a. Matthews, “On the significance of the H/E ratio in wear control: A nanocomposite coating approach to optimised tribological behaviour,” Wear, vol. 246, no. 1–2, pp. 1–11, 2000.

[23]     A. Matthews and A. Leyland, “Materials Related Aspects of Nanostructured Tribological Coatings,” in 51st. Annual Technical Conferebce, 2008, pp. 40–45.

[24]     L. Wang, Y. Gao, Q. Xue, H. Liu, and T. Xu, “A novel electrodeposited Ni – P gradient deposit for replacement of conventional hard chromium,” Surf. Coat. Technol., vol. 200, pp. 3719–3726, 2006.