The Effect of Building Blocks Layout on Indoor Thermal Comfort and Energy Consumption of Building in the Humid Subtropical Climate of Caspian Coast
Subject Areas : Space Ontology International JournalZahra Sorayaei 1 , Raheleh Rostami 2 , Fatemeh Mozaffari Ghadikolaei 3
1 -
2 -
3 -
Keywords: PMV Index, energy consumption, Thermal Comfort, DesignBuilder, Building blocks layout,
Abstract :
Cities use a lot of energy sources and they form more than 70 percent of global carbon emissions. It is very important to measure the relationship between urban form and energy consumption. The form of different building blocks in the city can create different microclimates and subsequently affect the thermal comfort and energy performance of each building. Building blocks form includes different variables. The purpose of the research was to predict the effect of the layout pattern of building blocks on the thermal conditions of the building and the annual energy consumption of the building. The general pattern of building block layout (discrete, linear, centripetal) and its characteristics, including length, depth and direction, were considered as independent variables of the research and the annual energy consumption of the building as a dependent variable. The thermal conditions in the building are based on the PMV thermal index as a mediating variable. This research is a quantitative study that includes a literature review and research and software analysis. Accordingly, the samples of building block layouts based on typical patterns in the study area located in the CFA climate were simulated using DesignBuilder software and the results were compared with each other results. Energy consumption results have shown a direct relationship with the thermal conditions of the building. The layout patterns of the building block in the form of a medium-depth centripetal (annual energy consumption: 52718.5 wh/m2) and a short-length linear (annual energy consumption: 54127 wh/m2) can be considered as favorable options in terms of annual energy consumption. Also, changing the direction of building blocks with a linear form causes a significant change in energy consumption (It increases by 10.7% compared to the short linear pattern), and in the discrete pattern, considering designing strategy like insulation for external walls are important to prevent heat loss.
Adachi, Y. & Ikegaya, N. & Satonaka, H. &A, Hagishima. (2020). Numerical simulation for cross-ventilation flow of generic block sheltered by urban-like block array. Building and Environment, 185, 107-174 .
Alipour kouhi, P., Zarabadi, Z.S., Majedi, H. (2021). Reflection on Quantitative and Qualitative Methods of Urban Form-Morphological Studies (Approaches and Techniques); Case Study: Historical Texture of Khorramabad. Journal of Architect, Urban Design & Urban Planning, 14(35), 223-238.
Allegrini, J. & Dorera, V. & Carmeliet, J. (2012). Influence of the urban microclimate in street canyons on the energy demand for space cooling and heating of buildings. Energy and Buildings, 55, 823–832.
Andreou, E. (2014). The effect of urban layout, street geometry and orientation on shading conditions in urban canyons in the Mediterranean. Renewable Energy, Vol:63, 587- 596.
A.S. of H.R. and A.-C.E. (ASHRAE), ASHRAE Standard 55 – Thermal Environmental Conditions for Human Occupancy, ASHRAE, Atlanta, 1992.
Azizi, Mohammad Mehdi. & Javanmardi, Komar. (2017). The effects of urban block forms on the patterns of wind and natural ventilation. Procedia Engineering, 180, 541 – 549.
Castaldo, V. L. & Pisello, A. L. & Piselli, Cristina. & Fabiani, C. & Cotana, F. & Santamouris, M. (2018). How outdoor microclimate mitigation affects building thermal-energy performance: a new design-stage method for energy saving in residential near-zero energy settlements in Italy. Renewable Energy, 127, 920-935.
D'Agostinoa, Delia. & Mazzarella, Livio. (2019). What is a nerly zero energy bulding? Overview implementation and comparison of definition. Journal of Building Engineering, 21, 200-212.
Gobakis, K. & Kolokotsa, D. (2017). Coupling building energy simulation software with microclimatic simulation for the evaluation of the impact of urban outdoor conditions on the energy consumption and indoor environmental quality. Energy and Buildings, 157, 101-115.
Hadi Rezaei Rad,Narges Afzali ,Measuring effects of building orientation and vegetation on thermal comfort by ENVI-met (Case study: Maslak area, Istanbul) ,A|Z ITU Journal of Faculty of Architecture , ,2021 ,pp. 127-137.
Heravi, Gh. & Qaemi, M. (2014). Energy Performance of Buildings: The Evaluation of Design and Construction Measures Concerning Building Energy Efficiency in Iran. Energy and Buildings, 75, 456–464
.Huang, K. T. & Li, Y. (2017). Impact of street canyon typology on building’s peak cooling energy demand: a parametric analysis using orthogonal experiment. Energy and Buildings, 154, 448-464.
Ko, Y. (2013). Urban Form and Residential Energy Use: A Review of Design Principles and Research Findings. Journal of Planning Literature, 28, 327-351.
Mahmoud, Hatem. (2019). Effect OF URBAN FORM ON OUTDOOR THERMAL COMFORT OF GOVERNMENTAL RESIDENTIAL BUILDINGS: NEW ASWAN AS A CASE STUDY, EGYPT. Journal of Engineering Sciences Assiut University Faculty of Engineering, 47, 309–325.
Mangan, Suzi Dilara., Oral, Gul Koclar,. Kocagil, Idil Erdemir, & Sozen, Irem. (2021). The impact of urban form on building energy and cost efficiency in temperate-humid Zones .Building Engineering, , vol.33, 101626.
Mehdizadeh Siraj, Fatemeh; Nasrullahi, Farshad. (2013), "The effect of the juxtaposition of mass and space in building blocks on the thermal behavior inside the building", Safa, No. 63, pp. 36-46.
M.Galal, & Omar. J. Sailor, David. Mahmoud, Hatem. (2020). The impact of urban form on outdoor thermal comfort in hot arid environments during daylight hours, case study: New Aswan. Building and Environment, 184, 1-15.
Moradkhani, Ayoub. Nikghadam, Nilofar. Tahbaz, Mansoure. (2018). Indicators affecting energy consumption of housing patterns at the neighborhood scale with emphasis on energy efficiency (case study of Sanandaj city). New attitudes in human geography. 1, 340-357.
Mortezai, Golnaz., Mohammadi, Mahmood., Nasrallahi, Farshad, & Ghaleh noei. (2015). Morphological investigation of new residential contexts in order to optimize primary energy consumption. 24, 1-14.
Pomfret, Laura. & Arman.Hashemi. (2017). Thermal comfort in zero Energy Building. procedia Engineerimg, 134, 825-834.
Quana, S. Jige. & Wub, J. & Y. Wangb. & Z. Shib. & T. Yangb. & P. Yang. (2016). Urban Form and Building Energy Performance in Shanghai Neighborhoods. Energy Procedia, 88, 126 – 132.
Rezaei, Rad Hadi. & Khodaee, Zahra. & Ghiai, Mohammad Mehdi. & Tabe Arjmand. & Haj Assad, Mamdouh E. (2021). The quantitative assessment of the effects of the morphology of urban complexes on the thermal comfort using the PMV/PPD model (acase study of Gheytariyeh neighborhood in Tehran). International Journal of Low-Carbon Technologies, 16, 672–68.
Rodríguez-Álvarez, J. (2016). Urban Energy Index for Buildings (UEIB): A new method to evaluate the effect of urban form on buildings’ energy demand. Landscape and Urban Planning, 148, 170–187.
Rode, P., keim, C., Robazza, G., Viejo, p., Schofield, J. (2014). Cities and energy: Urban morphology and residential heat-energy demand. Environment and planning B: planning and Design, vol.41, 138-162.
Saif al-Dini, F., Ziari, K., Ahmadpour, A., and Nikpour, A. (2011). Explaining the distribution and compactness of urban form in Amol with the approach of sustainable urban form. Human Geography Research, 44(80), 155-176.
Sanayeayan, H., Mehdizadeh Seraj, F., Nasrollahi, F., Mofidi Shemirani, M., (2013). The Impact of Adjacencies on Interior Thermal Behavior. 23(4), 35-46.
Sanaieian, H. & Tenpierik, M. & K, van den Linden. & Seraj, F. M. & Shemrani, M. M. (2014). Review of the impact of urban block form on thermal performance, solar access and ventilation, Renewable and Sustainable Energy Reviews, 38, 551–560.
Sant Amouris, M.N. & Livada, I. & Koronakis, I. & Georgakis, C. Argiriou, A. & D. N Assimimakopoulos. (2001). On the impact of urban climate on the energy consumption of buildings. Solar Energy, 70, 201–216.
Santamouris, M. & Haddad, Sh. & Saliari, M. & Vasilakopoulou, K. & Synnefa, A. & Paolini, R. Ulpiani, G. & Garshasbi, S. & Fiorito, F. (2018). On the Energy Impact of Urban Heat Island in Sydney. Climate and Energy Potential of Mitigation Technologies. Energy and Buildings, 166, 154-164.
Taleghani, M. & Kleerekoper, L. & Tenpierik, M. & Dobbelsteen A. van den. (2014). Outdoor thermal comfort within five different urban forms in the Netherlands, Building and environment, 83, 65-78.
Taleghani, M. & Tenpierik, M. & Kurvers, S. & Dobbelsteen, A. v. d. (2013). A review into thermal comfort in buildings. Renewable and Sustainable Energy Reviews, 26, 201–215.
Taleghani, M. Tenpierika, M. Dobbelsteen, A. van den. de Dear, R. (2013). Energy use impact of and thermal comfort in different urban block types in the Netherlands. Energy and Buildings, 67, 166–17.
Taleghani, Mohammad., Tenpierik, Martin., & Dobbelsteen, Andy van den. (2014). Indoor thermal comfort in urban courtyard block dwellings in the Netherlands. Building and Environment, 82, 66-579.
US Energy Information Administration, 2021.
Zebardast E, Azizi M M, baghernejhad E. (2020). Analyzing Relationship between Urban Form and Disaster Resilience at Tehran Metropolis Neighborhoods. Journal of Housing and Rural Environment (JHRE); 39 (170), 15-28.
Zhang, J.C. & L. C, Kiang Hen. & D. J. C, Malone-Lee. & P, Hii. & K. S, Janssen. B. K, Leung. (2012). Evaluating environmental implications of density: A comparative case study on the relationship between density, urban block typology and sky exposure. Automation in Construction 22, 90–101.
Zinzi, M. Carnielo, E. (2017). Impact of urban temperatures on energy performance and thermal comfort in residential buildings. The case of Rome, Italy. Energy and Buildings, 157, 20-29