Investigation of the Quality and Pollution Level of Waste Water Obtained from Recycling of MDF Wastes

Subject Areas : natural resorces

bita moeizi ¹ ( Assistant Professor, Faculty of Agriculture and Natural Resources, University of Mohaghegh Ardabili, Ardabil, Iran * (Corresponding author). )
Mohamad Ahmadi ² ( Associated Professor, Faculty of Agriculture and Natural Resources, University of Mohaghegh Ardabili, Ardabil, Iran )
Aida Moezzipour ³ ( Ph.D graduated, Faculty of Natural Resources, University of Tehran, Karaj, Iran )
Ali Abdolkhani ⁴ ( Associated Professor, Faculty of Natural Resources, University of Tehran, Karaj, Iran )

Received: 2017-09-19 Accepted : 2018-01-24 Published : 2019-11-22

Keywords: MDF wastes, ohmic heating method, recycling, hydrothermal, waste water quality,

Abstract :

Background and Objectives: The cellulose industry is one of the most important and influential industries in developed and developing countries. Waste recycling is one of the activities that have recently been considered in this industry. Despite the enormous economic and environmental benefits of recycling, this process results in the generation of effluent which is important for the study of its pollution. Method: For recycling of MDF wastes two different method including hydrothermal and ohmic heating were utilized. Hydrothermal method was done at 105˚C for 150 min and ohmic heating method was carried at 100 ˚C for 2 different time duration (2 and 4 min).The chemicals contained in waste waters obtained from recycling of MDF wastes were determined using of chromatography and mass spectroscopy (GC/MS) test.  Additionally, pH value, BOD, COD, TDS and TSS for all kinds of waste waters were measured. Finding: The results showed that the nitrogenous compounds had the most concentration in waste water obtained from hydrothermal method, and in the wastewater produced by ohmic method, both the 2 and 4 mins. Discussion and Conclusion: The most active materials were the acids. The obtained waste waters included chloride phenol compounds, tannins and lignin derivatives and their BOD, COD and suspended compounds were higher than the requirements defined in standard. Filtration method can be used for decreasing the amount of suspended solids.    

References:

1. Kargarfard, A., Hoseinzadeh, A., Nourbakhsh, A., Khajeh, K.H., Hajihasani, R., 2005. Investigation on medium density fiberboard (MDF) properties produced from poplar wood (P.nigra). Pajhouhesh and Sazandegi, No.68, pp. 38-48. (In Persian)


2. Athanassiadou, E., Roffael, E.,Manthanis, G., 2005. Medium Density Fibreboards (MDF) from Recycled Fibres, www.Academia.edu, 9pp.


3. Rohdes, G.T.A., Gehrts, E., 1995.  MDF - A new member of the family of woodbased panels. Tappi Proceedings. Europan plastic laminates forum, Vol.4 (1), pp. 9-15.


4. Habibi, M.R., Mahdavi, S., Hoseinkhani, H., Sepidehdam, M.J., 2006. Invesitgation on possibility of MDF production from reed. Iranian Journal of Wood and Paper Science Research, Vol.19, (2), pp. 242-225. (In Persian)


5. Dix, B., Schafer, M., Roffael, E., 2001. Using fibers from waste fiberboards pulped by a thermo-chemical process to produce medium density fiberboard (MDF). Holz als Roh und Werkstoff, Vol 59(4), pp. 276-276.


6. Michanickl, A., Boehme, C., 2003. Method for recovering chips and fibers of bonded wood materials involves passing of steam through a vessel with such materials which have been soaked with a heated impregnation solution, Patent No. DE10144793, WO03026859.


7. Manthanis, G., Athanassiadou, E., Nakos, P., Coutinho, A., 2004. A new recycling process for waste panels, in: Proc. of European COST E31 Conference: “Management of recovered wood”. Ed. C. Gallis, Thessaloniki, Greece, pp.  204-210.


8. Lykidis, C.H., Grigoriou, A., 2008. Hydrothermal recycling of waste and performance of recycled wooden particleboard, Waste management Journal, Vol 28, pp. 57-63.


9. Roffael, E., Dix, B., Schneider, T., 2001. Thermomechanical (TMP) and chemothermomechanical pulps (CTMP) for medium density fibreboards (MDF), Holzforschung, Vol 55, pp. 214-218.


10. Nicewics, D., Leszek, D., 2010. Recycling of insulation boards by reuse” Annals of Warsaw University of Life Sciences – SGGW. Forestry and Wood Technology Journal, Vol 72, pp. 57-61.


11. Bartlett, C., New, J., 2012. Recycling MDF: are we there yet?” Panel perspectives, www.wbpionline.com, 5 pp.


12. Kakavandi, B., Joneidi, A., Ghasemi, A., Gholizadeh, A., 2012. Studying Effluent Quality of Wastewater Treatment Plant. Scientific research journal of Health System Research (HSR), Vol. 8 (4), pp.706-713. (In Persian)


13. Chen, S.H., Li, S., Mu, J., Feng, Y., 2015. Influence of urea formaldehyde resin on the pyrolysis characteristics and gas evolution of waste MDF. Wood Research Journal, Vol. 60 (1), pp. 113-124.


14. Vaziri, V., Ariayi-Monfared, M., Rezayati, P., Jaafari-Petroudi, S.R., Introducing different methods for treatment of cellulosic industries effluent, The first conference of natural resources management, March 2014, Gonbade Kavous, Iran. (In Persian)


15. Hamzeh, Y., 2014. Management of water and effluent in pulp and paper industries. Iranian Student Book Agency. (In Persian)


16. H, Holik., 2006. Handbook of paper and board, John Whily & Sons