Experimental Study of the Effect of Protective Plates Lengths on Reducing the Depth of the Cylindrical Bridge Pier

Subject Areas : Subjects

Benyamin Daniyari ¹ (Former M.Sc. Student of Hydraulic Structures, Civil Engineering Department, Islamic Azad University, Dezful Branch, Iran.)
Ebrahim Nohani ² (Assistant Professor, Department of civil Engineering, Materials and Energy Research Center, Dezful Branch, Islamic Azad University, Dezful, Iran.)

Received: 2019-05-18 Accepted : 2021-09-01 Published : 2022-07-23

Keywords: Scour, Protective protection, Laboratory model, Cylindrical bridge pier,

Abstract :

Introduction: Local scouring that occurs due to human construction of structures in the course of rivers flow can lead to erosion of the river's bottom and threatens to change the natural flow of the river. One of the indirect methods of reducing scouring is the use of protective structures.
Methods: In this research, the effect of protective sheet length on the scour depth reduction of cylindrical base was investigated.
Findings: The results of the experiments showed that the laying of protective plates could reduce the scour depth to 69.50%. Also, the best relative length (the length of the protective plate to the width of the bridge base, L / b) of the protective plates is equivalent to one, and with the increase in the length of the protective plates, the effect of the plate length on the scour depth reduction was reversed, so that reducing the scour depth for the relative length of 5.0 and 2 are respectively, 50% and 60% more than the control (without protective plates), and in all experiments, the relative depth of scour has increased with increasing the flow rate.
 

References:

1.       Nohani, E., & Moalaimazrae, A. 2018 Organization and Stabilization of River Coastal Using a Mathematical Model (Case Study: Zohreh River). Journal of Natural Environmental Hazards, 7(17), 83–98.

2.       Shafa'i-Bajastan, M.H. 2017. Theoretical and practical hydraulic principles of sediment transport, Shahid Chamran University Publications, Ahvaz, Iran. P. 125. [In Persian].

3.       Breusers, H. N. C., Nicollet,  G. and  Shen, H. W. 1977. Local scour around cylindrical piers. Journal of  Hydraulic Research. 153(2): 211-252.

4.       Raudkivi , A. J. 1998. Loose boundary hydraulics. IAHR, A. A, Balkema, Rotterdam, The Netherlands pp: 1-538.

5.       Annandale GW, 2006. Scour echnology. McGraw Hill Publications, USA. pp: 1-230.11).

6.       Melville BW and Coleman SE, 2000. Bridge scour. Water Resources Publications, Colorado, USA.

7.       Gupta UP, Ojha CSP and Shrma N, 2010. Enhancing utility of submerged vanes with collar. Journal of Hydraulic Engineering, ASCE 136(9):651-655.

8.       Emamgholizadeh, S., and Nohani, E. 2017.  Application of the Submerged Vanes on Reduction of Local Scour around the Bridge Abutment with Rounded Nose. Irrigation and Drainage Structures Engineering Research, 2017; 18(68): 113-128.

9.       Nohani, A., Heydaranjad, M., and Shafa'i-Bojestan, M. 2013. Laboratory study of the effect of the foundation gap on the amount of erosion around the base of the cylindrical bridge at the position of 60 degrees of the river arch. National conference on optimal use of water resources, Dezful - Islamic Azad University, Dezful branch. [In Persian].

10.    Nohani E, Shafai Bejestan M, Masjedi A R. Determination of Stable Riprap Diameter Around Cylindrical Bridge Pier in the River Bends. JWSS. 2014; 18 (68) :33-42

11.   Hojjatkhah, A., and Soleimani-Babarsad, M. 2015. Laboratory investigation of the effect of protective structure on reducing scour depth around the bridge foundation. Second Regional Conference on Civil Engineering, Qaimshahr, Islamic Azad University, Qaimshahr Branch, Qaimshahr, Iran. [In Persian].

12.   Samimibehbehan, T., Barani, G., Rahimkhani, M., and Khanjani, M. 2016. Laboratory investigation of the effect of submerged plates on scouring of bridge foundations. Pages 25 to 31. Proceedings of the National Conference on Management of Irrigation and Drainage Networks, April 12-14, Shahid Chamran Ahvaz University, Ahvaz, Iran. [In Persian].

13.   Ghorbani, B and Karimi, A, 2007. A comparison of single and double submerged vanes effect on the scour occurring at a cylindrical pier. Pp. 260-276. Proceeding of 6th Conference of Hydraulic, Sept. 4-6, Shahre Kord, Iran.

14.    Nohani, E., & ebrahimi, S. 2019. Experimental Investigation of the Collar and Vanes on Reduction the Scour Depth of Cylindrical Piers. Iranian Journal of Soil and Water Research, 50(2), 411-424.

15.   Shojaee, P., Farsadizadeh, D., Hoseinzadeh Dalir, A., Salmasi, F., Ghorbani, M. (2012). Application of Submerged Vanes at Cylindrical Bridge Pier as a Scour Countermeasure. Water and Soil Science, 22(1), 91-109.

16.   Chiew, Y., M, and Melville, B., W. 1987. Local Scour around Bridge Piers. Journal of Hydraulic Research Taylor & Francis, 25 (1): 15–26.

17.   Raudkivi, A. J., and Ettema, R. 1983. Clear-water scour at cylindrical piers. Journal of Hydraulic Engineering, 109(3): 338–350.

18.   Oliveto, G., and Hager, W. H. 2002. Temporal evolution of clear-water pier and abutment scour. Journal of Hydraulic Engineering, 128(9): 811–820.

19.   Bozkus, Z., and Yildiz, O. 2004. Effects of inclination of bridge piers on scouring depth. Journal of Hydraulic Engineering, 130(8): 827–832.

20.   Sheppard, D. M., Odeh, M., and Glasser, T. 2004. Large scale clear-water local pier scour experiments. Journal of Hydraulic Engineering, 130(10): 957–96.

21.   Kumar, V., Raju, K. G. R., and Vittal, N. 1999. Reduction of local scour around bridge piers using slots and collars. Journal of Hydraulic Engineering, 125(12):1302–1305.