Experimental Investigation of the Effect of Sills on the Hole of Local Scour Around the Bridge Pier with Different Geometric Shapes

Subject Areas : Business Administration and Entrepreneurship

Mansour Khalaj ¹ (Former M.Sc. Student of Hydraulic Structures, Civil Engineering Department, Islamic Azad University, Dezful Branch, Iran.)
Ebrahim Nohani ² (Assistant Professor, Department of civil Engineering, Materials and Energy Research Center, Dezful Branch, Islamic Azad University, Dezful, Iran.)
Ali Afrous ³ (Assistant Professor, Department of Water Engineering, Dezful Branch, Islamic Azad University, Dezful, Iran.)

Received: 2021-09-08 Accepted : 2023-05-13 Published : 2023-04-21

Keywords: Scour, Aquifer, pier, Bridge, Shapes, Experimental,

Abstract :

Abstract Introduction: A physical model was prepared to investigate the effect of the geometric shape of the bridge pier with the abutment attached to it on the reduction of scour depth. This model was made of a laboratory flume with a length of 7.5 meters, a width of 30 cm, a depth of 45 cm with a variable slope and a glass body with bridge pier width of 4 cm were used. For bed sediments, a layer of natural river sand with an average diameter of 0.9 mm and a standard deviation coefficient of 1.1 and a uniformity coefficient of 1.25 were selected and used in a layer with a thickness of approximately 14 cm for experiments. Methods: The geometric shape of the bridge piers, as well as the presence of the footing, prevents direct contact of the descending current, reduces the activity of horseshoe vortices and thus reduces the scouring speed, and delays the scouring start time. Findings: According to the results of the experiments, the greatest decrease in scour depth was related to (0.26 descent and p1 base). The results showed that in the same condition, the relative scour depth at p1 base was less than other bases and reached its maximum in the control base. Also, the relative scour depth increased with increasing the number of landings in the same position. The abutment attached to the bridge base has reduced the scour depth by 29.6%.

References:

1.       Movahedi, N., dehghani, A. A., Zahiri, A. R., & aarabi, M. J. (2015). Investigation the efficiency of using bed sill in reduction of scour around single pier and side-by-side piers. Journal of Water and Soil Conservation, 21(6), 191-205. [In Persian].

2.       Kabiri, SH., HosseinzadehDelir., A, Shalmasi., F, and Farsadizadeh., D. 2019. The effect of aquifer placement in reducing the maximum scour depth under submerged pipes under unidirectional flow. 9th Iran Hydraulic Conference, November 2019, Tarbiat Modares University. [In Persian].

3.       Kayaturk, S.Y. 2005. Scour and Scour Protection at Bridge Abutment. PhD Thesis, Middle East Technical University, Ankara, Turkey, 213p   2005

4.       Raudkivi, A.J., and Ettema, R. 1983. Clear-Water Scour at Cylindrical Piers. J. Hydr. Engin. 109: 3. 338-350

5.       Tafarojnoruz, A., Gaudio, R., and Calomino, F. 2012. Control evaluation of flow-altering countermeasures against bridge pier scour. J. Hydr. Engin. 138: 3. 297-305.

6.       Bozkus, Z., and Yildiz, O. (2004). Effects of inclination of bridge piers on scouring depth. Journal of Hydraulic Engineering, 130(8), 827–832.

7.       Kumar, V., Raju, K. G. R., and Vittal, N. (1999). Reduction of local scour around bridge piers using slots and collars. Journal of Hydraulic Engineering, 125(12), 1302–1305.

8.       sheppard, D. M., Odeh, M., and Glasser, T. (2004). Large scale clear-water local pier scour experiments. Journal of Hydraulic Engineering, 130(10),957-963.

9.       Oliveto, G., and Hager, W. H. (2002). Temporal evolution of clear-water pier and abutment scour. Journal of Hydraulic Engineering, 128(9), 811–820.

10.   Nohani, E., ebrahimi, S. Experimental Investigation of the Collar and Vanes on Reduction the Scour Depth of Cylindrical Piers. Iranian Journal of Soil and Water Research, 2019; 50(2): 411-424.doi: 10.22059/ijswr.2018.257701.667909