Investigating the effects of 2.5 mol% Ce doping on electrostriction behavior of lead-free (Ba0.85Ca0.15)(Zr0.1Ti0.9)O3 ceramics
Subject Areas : journal of New Materialsراضیه حیاتی 1 , Mohammad Ali Bahrevar 2 , toraj ebadzadeh 3
1 - دانشجوی دکترای مهندسی مواد، پژوهشگاه مواد و انرژی، کرج
2 - Semiconductor Division, Materials and Energy Research Center, 31787/316 Karaj, Iran
3 - استاد و عضو هیات علمی پژوهشگاه مواد و انرژی، کرج
Keywords: Lead free BCZT, CeO2, ferroelectric, electrostriction,
Abstract :
Lead-free [(Ba0.85Ca0.15)1-xCex/2](Zr0.1Ti0.9)O3 (BCCexZT) piezoceramics were synthesized using conventional solid-state ceramic processing. Sintering was carried out in the temperature range of 1350 - 1450 °C for 4 h. The microstructure and phase composition were investigated by scanning electron microscopy and X-ray diffraction. Polarization and strain measurements were done using a modified Sawyer-Tower circuit and a commercial aix-PES piezoelectric evaluation system was used to record the variations of polarization and strain with temperature. The addition of CeO2 decreased the Curie temperature of BCZT to near room temperature and consequently a high permittivity value was obtained at room temperature. Additionally, the temperature dependence of strain and polarization showed that electrostrictive coefficients calculated from the unipolar and bipolar loops were approximately the same. Since the Curie temperature of BCCe0.025ZT is shifted to around room temperature, 90-100% of induced polarization and strain is attributed to the electrostriction effect. The highest electrostrictive coefficients of Q33= 0.063 m4/C2 and M33=3.4E-16 m2/V2 were obtained for BCCe0.025ZT ceramics with 2.5 mol% Ce, which are higher than the corresponding values in previous reports and make this composition as a candidate for electrostrictive applications.
References:
[1] J. Rödel, W. Jo, K. T. P. Seifert, E. M. Anton, T. Granzow, and D. Damjanovic, "Perspective on the development of lead-free piezoceramics," Journal of the American Ceramic Society, vol. 92, pp. 1153-1177, 2009.
[2] L. E. Cross and R. E. Newnham, "History of Ferroelectrics," in Ceramics and civilization: High-technology ceramics-Past, present and future vol. III, W. D. Kingery, Ed., ed. USA: The American Ceramic Society Inc., 1986.
1- Technische Universität Darmstadt
[3] J. Rödel, K. G. Webber, R. Dittmer, W. Jo, M. Kimura, and D. Damjanovic, "Transferring lead-free piezoelectric ceramics into application," Journal of the European Ceramic Society, vol. 35, pp. 1659-1681, 2015.
[4] W. Liu and X. Ren, "Large piezoelectric effect in Pb-free ceramics," Physical Review Letters, vol. 103, p. 257602, 2009.
[5] F. Li, L. Jin, and R. Guo, "High electrostrictive coefficient Q33 in lead-free Ba(Zr0.2Ti0.8)O3-
2% مولی سریم بر رفتار الکتروتنگش پیزوسرامیک عاری از سرب... / 112 بررسی اثر آلاییدن 5
x(Ba0.7Ca0.3)TiO3 piezoelectric ceramics," Applied Physics Letters, vol. 105, p. 232903, 2014.
[6] M. Acosta, N. Novak, G. A. Rossetti, and J. Rödel, "Mechanisms of electromechanical response in (1 − x)Ba(Zr0.2Ti0.8)O3-x(Ba0.7Ca0.3)TiO3 ceramics," Applied Physics Letters, vol. 107, p. 142906, 2015.
[7] F. Li, L. Jin, Z. Xu, and S. Zhang, "Electrostrictive effect in ferroelectrics: An alternative approach to improve piezoelectricity," Applied Physics Reviews, vol. 1, p. 011103, 2014.
[8] W. R. C. Bernard Jaffe, Hans Jaffe, Piezoelectric Ceramics. London & New York: Academic Press, 1971.
[9] C. Ang and Z. Yu, "High, Purely Electrostrictive Strain in Lead-Free Dielectrics," Advanced Materials, vol. 18, pp. 103-106, 2006.
[10] F. Xiao, W. Ma, Q. Sun, Z. Huan, J. Li, and C. Tang, "The electrostrictive effect and dielectric properties of lead-free 0.5Ba(ZrxTi1−x)O3–0.5(Ba0.75Ca0.25)TiO3 ceramics," Journal of Materials Science: Materials in Electronics, pp. 1-6, 2013/03/21 2013.
[11] H. Jin Hyun and H. Young Ho, "Dielectric Properties of (Ba1- x Cex )TiO3," in Japanese Journal of Applied Physics vol. 39, ed, 2000, p. 2701.
[12] D. Makovec, Z. Samardžija, and D. Kolar, "Solid Solubility of Cerium in BaTiO3," Journal of Solid State Chemistry, vol. 123, pp. 30-38, 1996.
[13] H. J. Hyun and H. Y. Ho, "Electrical Properties of Cerium‐Doped BaTiO3," Journal of the American Ceramic Society, vol. 84, pp. 1750-1754, 2001.
[14] Raziye Hayati, Mohammad Ali Bahrevar, Yadolah Ganjkhanlou, Virginia Rojas, and J. Koruza, "Electromechanical properties of Ce-doped (Ba0.85Ca0.15)(Zr0.1Ti0.9)O3 lead-free piezoceramics," Advanced Ceramics, 2019.
[15] Jigong Hao, Wangfeng Bai, Wei Li, and J. Zhai, "Correlation between the microstructure and electrical properties in high-performance (Ba0.85Ca0.15)(Zr0.1Ti0.9)O3 lead-free piezoelectric ceramics," Journal of the American Ceramic Society, vol. 95, pp. 1998-2006, 2012.
[16] A. Chen, J. Zhi, and Y. Zhi, "Ferroelectric relaxor Ba(Ti,Ce)O3," Journal of Physics: Condensed Matter, vol. 14, p. 8901, 2002.
[17] L. P. Curecheriu, M. Deluca, Z. V. Mocanu, M. V. Pop, V. Nica, N. Horchidan, et al., "Investigation of the ferroelectric–relaxor crossover in Ce-doped BaTiO3 ceramics by impedance spectroscopy and Raman study," Phase Transitions, vol. 86, pp. 703-714, 2013.
[18] K. Uchino and S. Nomura, "Critical exponents of the dielectric constants in diffused-phase-transition crystals," Ferroelectrics, vol. 44, pp. 55-61, 1982.
[19] I. Coondoo, N. Panwar, H. Amorin, M. Alguero, and A. L. Kholkin, "Synthesis and characterization of lead-free 0.5Ba(Zr 0.2Ti0.8)O3-0.5(Ba0.7Ca0.3)TiO3 ceramic," Journal of Applied Physics, vol. 113, pp. 214107-6, 2013.
[20] C. A. Randall, N. Kim, J.-P. Kucera, W. Cao, and T. R. Shrout, "Intrinsic and Extrinsic Size Effects in Fine-Grained Morphotropic-Phase-Boundary Lead Zirconate Titanate Ceramics," Journal of the American
113 مجله مواد نوین/ جلد 9/شماره 3 / بهار 1398
Ceramic Society, vol. 81, pp. 677-688, 1998.
[21] J.-H. Park, B.-K. Kim, and S. J. Park, "Electrostrictive Coefficients of 0.9Pb(Mg1/3Nb2/3)O3-0.1PbTiO3 Relaxor Ferroelectric Ceramics in the Ferroelectricity-Dominated Temperature Range," Journal of the American Ceramic Society, vol. 79, pp. 430-434, 1996.
[22] R. Hayati, M. A. Bahrevar, T. Ebadzadeh, V. Rojas, N. Novak, and J. Koruza, "Effects of Bi2O3 additive on sintering process and dielectric, ferroelectric, and piezoelectric properties of (Ba0.85Ca0.15)(Zr0.1Ti0.9)O3 lead-free piezoceramics," Journal of the European Ceramic Society, vol. 36, pp. 3391-3400, 2016.
[23] J. Hao, Z. Xu, R. Chu, W. Li, P. Fu, J. Du, et al., "Structure evolution and electrostrictive properties in (Bi0.5Na0.5)0.94Ba0.06TiO3–M2O5 (M = Nb, Ta, Sb) lead-free piezoceramics," Journal of the European Ceramic Society, vol. 36, pp. 4003-4014, 2016.
[24] J. Hao, Z. Xu, R. Chu, W. Li, P. Fu, J. Du, et al., "Large electrostrictive effect and strong photoluminescence in rare-earth modified lead-free (Bi0.5Na0.5)TiO3-based piezoelectric ceramics," Scripta Materialia, vol. 122, pp. 10-13, 9// 2016.
[25] V. Bobnar, B. Malič, J. Holc, M. Kosec, R. Steinhausen, and H. Beige, "Electrostrictive effect in lead-free relaxor K0.5Na0.5NbO3–SrTiO3 ceramic system," Journal of Applied Physics, vol. 98, p. 024113, 2005.
[26] K. Uchino, S. Nomura, L. E. Cross, R. E. Newnham, and S. J. Jang, "Electrostrictive effect in perovskites
