Check Tic-coated Tungsten Carbide Tool Wear in Machining Steel

Subject Areas : Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering

M. Karimian ¹ (Assistant Prof., Department of Mechanical Engineering, Khomeinishahr Branch, Islamic Azad University, Isfahan, Iran)
, E. Mir Mohammad Sadeghi ² (Lecturer, Department of Mechanical Engineering, Khomeinishahr Branch, Islamic Azad University, Isfahan, Iran)
M. Mokhles Pour Esfahani ³ (MSc Student, Department of Mechanical Engineering, Khomeinishahr Branch, Islamic Azad University, Isfahan, Iran)
M. badakhshian ⁴ (MSc Student, Department of Mechanical Engineering, Khomeinishahr Branch, Islamic Azad University, Isfahan, Iran)

Received: 2016-01-19 Accepted : 2016-01-19 Published : 2014-02-20

Keywords: تراش کاری, سیال برشی پر فشار, سایش ابزار, دور اسپیندل, عمق براده, پیشروی,

References:

[1] الحافی،حسن،ماشین کاری های پیشرفته،دانشگاه صنعتی خواجه نصیرالدین طوسی،1390.

[2] گلکارپور. هانی، دهقانی. نریمان ، بررسی عمر ابزار با توجه به پارامترهای حرارت ، صافی.

[3] Derflinger V., Brandle H., Zimmermann H., New hard/lubricant coating for dry machining, Surface and Coatings Technology, vol. 113, No. 3, 1999, pp. 286–292.

[4] Sarma D.K., Dixit A., A comparison of dry and aircooled turning of grey cast iron with mixed oxide ceramic tool, Journal of Materials Processing Technology, vol. 190, No. 1-3 , 2007 , pp. 160-172.

[5] Dhar N.R., Kamruzzaman M., Ahmed M., Effect of minimum quantity lubrication (MQL) on tool wear and surface roughness in turning AISI-420B steel, Journal of Materials Processing Technology, vol. 172, No. 2, 2012, pp. 299-304.

[6] Machado, A.R., Wallbank, J., The effect of extremely low lubricant volumes in machining, Wear, vol. 210, No. 1, 1997, pp. 76-82.

[7] Xavior M.A., Adithan M., Determining the influence of cutting fluids on tool wear and surface roughness during turning of AISI 304 austenitic stainless steel, Journal of Materials Processing Technology, Vol. 209, No. 2, 2009, pp. 900-909.