Using finite element model in calculation of stress concentration factor around an elliptical hole in composite hybrid lamina
Subject Areas : Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering
1 - Islamic Azad University Ahvaz Branch
Keywords:
Abstract :
References:
Birgani, P. T., & Shishesaz, M. (2017). Symmetric hole stress concentration in a hybrid composite lamina subjected to matrix plasticity. Journal of Mechanical Science and Technology, 31(7), 3337-3345.
Taghipour Birgani, P. (2015). The effect of volume fractions on hole stress concentration in composite lamina subjected to matrix plasticity. Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering, 8(2), 137-148.
Saini, P. K., & Kushwaha, M. (2014). Stress variation around a circular hole in functionally graded plate under bending. International Journal of Mechanical and Mechatronics Engineering, 8(3), 538-542.
Birgani, P. T., & Shishesaz, M. (2017). Symmetric hole stress concentration in a hybrid composite lamina subjected to matrix plasticity. Journal of Mechanical Science and Technology, 31(7), 3337-3345.
Khechai, A., Tati, A., & Guettala, A. (2014). Finite element analysis of stress concentrations and failure criteria in composite plates with circular holes. Frontiers of Mechanical Engineering, 9(3), 281-294.
Wankar, A., Bayas, J., & Mishra, H. (2016) Relation between hole diameter to width ratio and scf of rectangular plate having central circular hole, IJARIIE, 2(2).
Hu, F. Z., Soutis, C., & Edge, E. C. (1997). Interlaminar stresses in composite laminates with a circular hole. Composite structures, 37(2), 223-232.
Wari, R., & Lalge, V. (2014). Analysis of stress concentration of laminated composite plate with circular hole. International Journal of Innovations In Engineering Research And Technology, 1.
Abu-Farsakh, G. A., Almasri, A. H., & Qa’dan, D. H. (2015). Stress concentration around a central hole as affected by material nonlinearity in fibrous composite laminated plates subject to in-plane loading. Science and Engineering of Composite Materials, 22(1), 31-36.
Dipen, B., & Dipal, P. (2015). Stress concentration factor converts into stress intensity factor using ANSYS. European Journal of Advances in Engineering and Technology, 2(1), 46-49.
