Synthesis of Cadmium Doped Nickel Copper Ferrite Nanoparticles and Investigation of Their Sensing Properties for the Detection of Acetonitrile in Little Accounts

Subject Areas :

Hossein  Emami ¹ (Department of Electrical and Computer Engineering, Majlesi Branch, Islamic Azad University, Isfahan, Iran.)
Hamid Reza  Ebrahimi ² (Center for Advanced Engineering Research, Majlesi Branch, Islamic Azad University, Isfahan, Iran.)

Received: 2020-09-02 Accepted : 2021-01-12 Published : 2021-10-23

Keywords: Nanoparticles Cadmium Doped Nickel Copper Ferrite Co, Precipitation Method Nanosensor Acetonitrile,

Abstract :

In this study cadmium doped nickel copper ferrite Ni0.5Cu0.5Fe2O4 (cd doped) nanoparticles with spinel structure were synthesized using co-precipitation method. The nanoparticles were employed as a gas sensing material. X-ray diffraction (XRD), X-ray fluorescence (XRF) and transmission electron microscopy (TEM) techniques were used to characterize the nanoparticles structure. The sensing behavior of the nanoparticles was examined in the presence of different gases including. Acetone, acetonitrile, acrylonitrile, formamide, caron tetrachloride, vinyl acetate, ethanol, ammonia, and methanol. The characterization process was performed for a concentration of a 200 ppm and within a temperature interval from 50 ˚C to 300 ˚C and the best sensing behavior was found to be at 200 ˚C. Furthermore, various concentrations of acetonitrile gas at 200 ˚C within a concentration interval of 20 to 200 ppm were tested and it is found that the higher concentrations will result in a better response.

References:

[1] P. B. Koli, K. H. Kapadnis & U. G. Deshpandem "Nanocrystalline-modified nickel ferrite films: an effective sensor for industrial and environmental gas pollutant detection," J. Nanostructures Chem, vol. 9, pp. 95-110, 2019.

 

[2] Z. Adamyan1, A. Sayunts, V. Aroutiounian, E. Khachaturyan, M. Vrnata, P. Fitl & J. Vlček, "Nanocomposite sensors of propylene glycol, dimethylformamide and formaldehyde vapors," J. Sens. Sens. Syst, vol. 7, pp. 31–41, 2018.

 

[3] D. R. Patil & L. A. Patil, Room temperature chlorine gas sensing using surface modified ZnO thick film resistors, Sens. Actuators B, vol. 123, pp. 546– 553. 2007.

 

[4] J. A. C. De Paiva, M. P. F. Grac¸ A. J. Monteiro, M. A. Macedo & M. A. Valente, "Spec troscopy studies of NiFe₂O₄ nanosized powders obtained using coconut water," J. Alloys Compd. Vol. 485, pp. 637–641, 2009.

 

[5] S. Anjum, H. G. Jaffari, A. K. Rumaiz, S. M. Rafique & I. S. Shah, "Role of vacancies intransport and magnetic properties of nickel ferrite thin films," J. Phys. D. Appl. Phys, vol. 43, pp. 265-001, 2010.

 

[6] A. Sutka, G. Mezinskis, S. Lagzdina & G. Bebris, "Effect of cooling conditions on nano-sized NiFe₂O₄ electrical properties," Adv. Mater. Res, vol. 222, pp. 263 -266, 2011.

 

]8 [ف. عربلو نره یی، ر. معمارزاده، ف. پناهی، م. دوازده‌امامی، س. جوادپور و م. ح. شریعت، "سنسور دما پایین گاز منواکسید کربن برپایه کامپوزیت لایه‌ نازک   Fe(II)(salen)/ PEDOT:PSS" مجله فرآیندهای نوین در مهندسی مواد، جلد 1، شماره 12، 1397.

 

[9] A. A. Sagade & R. Sharma, "Copper sulphide (CuxS) as an ammonia gas sensorworking at room temperature," Sens. Actuators B, vol. 133, pp. 135–143, 2012.

 

[10] T. Sathitwitayakul, M. V. Kuznetsov, I. P. Parkin & R. Binions, "The gas sensing properties of some complex metal oxides prepared by self-propagating high-temperature synthesis", Mat. Lett, vol. 75, pp. 36–38, 2012.

 

[11] Z. Sun, L. Liu, D. Jia & W. Pan, "Simple Synthesis of CuFe₂O₄ nanoparticles as gas sensing materials", Sensors and Actuators B, vol. 125, pp. 144-148, 2007.

 

[12] S. Tao, F. Gao, X. Liu & O. Sorensen, "Preparation and gas-sensing properties of CuFe₂O₄ at reduced temperature", Materials Science and Engineering B, vol. 77, pp. 172-176, 2000.

 

[13] A. Sutka, M. Stingaciu, G. Mezinskis & A. Lusis, "An alternative method to modifythe sensitivity of p-type NiFe2O4 gas sensor," J. Mater. Sci, vol. 47, pp. 2856- 2863, 2012.

 

[14] Y. Tang, O. Zhang, Y. Li & H. Wang, "Highly selective ammonia sensors based onCo1−xNixFe₂O₄/multi-walled carbon nanotubes nanocomposites," Sens. Actua-tors, B, vol. 169, pp. 229–234, 2012.

 

[15] A. Sutka, M. Stingaciu, G. Mezinskis & A. Lusis, "Gas sensing properties of Zn dopedp-type nickel ferrite," Sens. Actuators, B, vol. 171–172, pp. 354–360, 2012.

[16] A. Sutka, J. Zavickis, G. Mezinskis, D. Jakovlevs & J. Barloti, "Ethanol monitoring by ZnFe₂O₄ thin film obtained by spray pyrolysis," Sens. Actuators, B, vol. 176, pp. 330–334, 2013.

 

[17] K. Wua , J. Lib & Ch. Zhanga, "Zinc ferrite based gas sensors: A review," Ceramics International, vol. 45, no. 9, pp.11143-11157, 2019.

 

[18] A. Pathania, P. Thakur, A. V. Trukhanov, S. V.Trukhanov, L. V. Panina, UlrikeLüders & A. Thakur, "Development of tungsten doped Ni-Zn nano ferrites with fast response and recovery time for hydrogen gas sensing application," Results in Physics, vol. 15, pp. 102531, 2019.

 

[19] H. R. Ebrahimi, M, Parish, G. R. Amiri, B. Bahraminejad & S. Fatahian, "Synthesis, characterization and gas sensitivity investigation of Ni_0.5Zn_0.5Fe₂O₄ nanoparticles," Journal of Magnetism and Magnetic Materials, vol. 414, pp. 55–58, 2016.