An investigation on metallurgical and mechanical properties of vacuum brazed Ti-6Al-4V to 316L stainless steel using Zr-based filler metal
الموضوعات :M.E Bajgholi 1 , R Soltani Tashi 2 , A.A Akbari Mousavi 3 , E Heshmat Dehkordi 4
1 - Department of Material Engineering, Science and Research Branch, Islamic Azad University, Tehran, Iran
2 - Department of Mechanical Engineering, Aliabad Katoul Branch, Islamic Azad University, Aliabad Katoul, Iran
3 - School of Metallurgy and Materials Engineering, College of Engineering, University of Tehran, Tehran, Iran
4 - Department of Engineering, Allameh University, Shahrekord, Iran
الکلمات المفتاحية: Brazing, Ti-6Al-4V, Stainless steel, Zr-Based Braze Alloy,
ملخص المقالة :
Both Ti-6Al-4V and 316L stainless steels are widely used as engineering alloys. Fusion welding of these two alloys is not easily possible due to their incomplete solubility in each other. Brazing is one of the best choices for joining dissimilar alloys. In this study, wettability experiments were done at 940 and 970 ºC for 5, 15 and 30 min. Also, joining of these two alloys was carried out at 940 and 970 ºC for 15 min. Optical and scanning electron microscope (SEM) were used for metallurgical observations. Moreover, mechanical properties of the brazed joint were investigated using microhardness test. The results showed that some reaction layers were composed in the brazed joint’s cross section. Ni-Ti intermetallic compounds were also observed in the brazed joint. Investigation of mechanical properties showed that hardness in the joint’s center is higher than base metals.
