The Effect of the Amount of Ferrous Sulfate in the Electrolyte on the Hardness of the Ni-Fe Alloy Coating Generated by Electrical Deposition Method
الموضوعات : Journal of Environmental Friendly MaterialsA Aghajafari 1 , M Noghani 2 , M Saghafi 3 , B Bostani 4
1 - Advanced Materials Engineering Research Center, Karaj Branch, Islamic Azad University, Karaj, Iran
2 - Department of Materials Science and Engineering, Faculty of Engineering, Imam Khomeini International University, Qazvin, Iran.
3 - Department of Materials Science and Engineering, Faculty of Engineering Buien Zahra, Imam Khomeini International University, Qazvin, Iran.
4 - Department of Materials Science and Engineering, Faculty of Engineering Buien Zahra, Imam Khomeini International University, Qazvin, Iran.
الکلمات المفتاحية:
ملخص المقالة :
Nickel-iron alloy coatings with different amounts of ferrous sulfate in plating bath on steel substrate under turbulence 250 rpm and current density 2.5 A d-1m-2 were created. the amount of ferrous sulfate added to the plating bath varied from 20 g l-1 to 80 g l-1. EDX test was taken from each sample. the amount of iron that precipitated from each plating solution in the alloy coating was obtained. it was observed that for the values of 20 g l-1, 40 g l-1, 60 g l-1, 80 g l-1 iron sulfates 21.29(wt.%), 43.35(wt.%), 51.19(wt.%), 58.8(wt.%) iron were deposited in the alloy coating, respectively. According to the SEM photos obtained from the samples, it was observed that only the sample contains 20 g l-1 ferrous sulfates in the plating bath without cracks and increasing the amount of ferrous sulfate in the plating bath leads to an increase in internal stresses in the coating, which is the main reason creating cracks. Finally, the hardness of the coatings was obtained, which was the highest hardness for the 20 g l-1 sample.
