Dopant and milling time effect on impedance and electrical properties of perovskite ceramics
الموضوعات : Journal of Theoretical and Applied Physics
Shristi Chaudhary
1
(Department of Physics, Chandigarh University, Gharuan, Mohali, Punjab, India.)
Mikanshi Chaudhary
2
(Department of Physics, Chandigarh University, Gharuan, Mohali, Punjab, India.)
Sheela Devi
3
(Department of Applied Sciences, MSIT, C-4, Janakpuri, New Delhi, India.)
Shilpi Jindal
4
(Department of Physics, Chandigarh University, Gharuan, Mohali, Punjab, India.)
الکلمات المفتاحية: ferroelectrics, XRD, SEM, PE, barium titanate,
ملخص المقالة :
Tungsten doped Barium Titanate (BT) with composition BaW0.05Ti0.95O3 (BWT) were prepared by using ball milling technique for different hours (10h, 20h and 30h). In the present paper, the microstructural, dielectric and impedance studies are discussed. The microstructural studies using XRD data reveals the formation of single phased tetragonal structure and perovskite structure. The dielectric properties of BT nanoceramics were significantly enhanced by the partial replacement of W (at B site) showing the diffuse phase transition at 80°C. Dielectric loss rises as the temperature rises. There is increase in charge carrier mobility which results in increased polarization and significant dielectric loss. Additionally, compared to the un-milled BWT ceramic sample, the 30h milled had superior dielectric characteristics with high dielectric constant and reduced loss. The nature of the phase transition was confirmed by the Curie-Weiss law and the ferroelectric analysis was carried by well-established P-E loops. The impedance studies were carried out by plotting Nyquist plots. The ac conductivity plot follows Arrhenius relation and the calculated activation energy confirms the negative temperature coefficient of resistance (NTCR) behavior of the material.
