The Investigating and comparing the spectroscopic impedance of the electrode modified by polypyrrole in the presence of chromium, copper and iron
الموضوعات :
Nafiseh Hajiabdolah
1
,
Mohammad Yousefi
2
1 - Department of Chemical Engineering, Arvand International Branch, Islamic Azad University, Abadan, Iran
2 - Department of Chemical Engineering, Arvand International Branch, Islamic Azad University, Abadan, Iran
الکلمات المفتاحية: spectroscopic impedance, polypyrrole, chromium, copper, iron.,
ملخص المقالة :
In this research, the synthesis of pyrrole polymer on graphite electrode has been investigated by cyclic voltammetry method in the potential range of -0.8 to 1.2 V in phosphoric acid, including calcium chloride as an electrolyte support, and the impedance technique has been used to determine the conductivity properties and resistance of 3 elements chromium, copper and iron are used. The Nyquist curves of each element at specific voltages and in a set of voltages have been discussed individually and comparatively, and these results have been obtained that at a certain voltage, the charge transfer resistance of the copper element has decreased compared to chromium and increased compared to iron. And the iron element has the lowest load transfer resistance value, and in checking the voltage set, we came to the conclusion that the lowest load transfer resistance of the iron element and the voltage is 0.2.
1. Randviir, E.P., A cross examination of electron transfer rate constants for carbon screen-printed electrodes using Electrochemical Impedance Spectroscopy and cyclic voltammetry. Electrochimica Acta, 2018. 286: p. 179-186.
2. Kurzweil, P., et al., Differential capacity as a tool for SOC and SOH estimation of lithium ion batteries using charge/discharge curves, cyclic voltammetry, impedance spectroscopy, and heat events: A tutorial. Energies, 2022. 15(13): p. 4520.
3. Tsierkezos, N.G. and U. Ritter, Electrochemical impedance spectroscopy and cyclic voltammetry of ferrocene in acetonitrile/acetone system. Journal of applied electrochemistry, 2010. 40: p. 409-417.
4. Chang, B.-Y. and S.-M. Park, Electrochemical impedance spectroscopy. Annual Review of Analytical Chemistry, 2010. 3(1): p. 207-229.
5. Lazanas, A.C. and M.I. Prodromidis, Electrochemical impedance spectroscopy─ a tutorial. ACS Measurement Science Au, 2023. 3(3): p. 162-193.
6. Macdonald, J.R. and W.B. Johnson, Fundamentals of impedance spectroscopy. Impedance spectroscopy: theory, experiment, and applications, 2018: p. 1-20.
7. Gharbi, O., et al., Revisiting cyclic voltammetry and electrochemical impedance spectroscopy analysis for capacitance measurements. Electrochimica Acta, 2020. 343: p. 136109.
8. Sharma, P.K., et al., Synthesis and characterization of polypyrrole by cyclic voltammetry at different scan rate and its use in electrochemical reduction of the simulant of nerve agents. Synthetic metals, 2010. 160(23-24): p. 2631-2637.
9. Buda, M., et al., Electrochemical Syntheses of Cyclo [n] pyrrole. Chemistry–A European Journal, 2010. 16(23): p. 6810-6819.
10. Ates, M., Review study of electrochemical impedance spectroscopy and equivalent electrical circuits of conducting polymers on carbon surfaces. Progress in Organic Coatings, 2011. 71(1): p. 1-10.
11. Huang, X.-y., L. Ling, and W.-x. Zhang, Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer. Journal of Environmental Sciences, 2018. 67: p. 4-13.
12. Hu, C.-Y., et al., Hexavalent chromium removal from near natural water by copper–iron bimetallic particles. Water Research, 2010. 44(10): p. 3101-3108.
13. Zeng, Y., et al., A hydrogen-ferric ion rebalance cell operating at low hydrogen concentrations for capacity restoration of iron-chromium redox flow batteries. Journal of Power Sources, 2017. 352: p. 77-82.
14. Hernández, H.H., et al., Electrochemical impedance spectroscopy (EIS): A review study of basic aspects of the corrosion mechanism applied to steels. Electrochemical impedance spectroscopy, 2020: p. 137-144.
15. Bonanos, N., et al., Applications of impedance spectroscopy. Impedance spectroscopy: Theory, experiment, and applications, 2018: p. 175-478.
