Effect of water stress on potato product in the drip irrigation (T-Tape)

الموضوعات :

F. Ghasemi Sahebi ¹ (Ms of irrigation and drainage, Razi University, Kermanshah, Iran)
M. Hekmat ² (Department of Agricultural Management, Shoushtar Branch, Islamic Azad University, Shoushtar, Iran.)
E. Pourkhiz ³ (Young Researchers Club, Islamic Azad University, Ghaemshahr Branch, Iran)

تاريخ الإرسال : 15 السبت , ربيع الأول, 1437 تاريخ التأكيد : 15 السبت , ربيع الأول, 1437 تاريخ الإصدار : 29 الأربعاء , جمادى الثانية, 1432

الکلمات المفتاحية: Border irrigation, Potato product performance, hemispheric wetted volume,

ملخص المقالة :

Using modern irrigation methods such as border irrigation is one way for an optimum usage of water. Potato, for this study, was cultured in a farm located at Kermanshah faculty of agriculture to evaluate the efficiency of border irrigation. The culture potato was the Agria variety and the applied treatment were 50, 75, and 100 percent of potato plant`s water requirement. Tapes were 12 m and the distance of levees was 75cm. Plant`s water requirement was determined by the evaporation pan method and the use of crop coefficient. Comparison of the product performance, efficiency of water consumption, hemispheric wetted volume, and moisture distribution skill were the evaluation indexes. Results showed that maximum product performance related to the 100 percent treatment was 34.455 tons per hectare; it was, for 75 and 50 percent treatments, 25.938 and 19.168 tons per hectare, respectively. Water use efficiency for 100, 75, and 50 percent treatments was 3.59, 3.55, and 3.53 kg of potato tuber for consuming 1m3 of water. Comparing the product performance in SAS software, treatments were classified in different groups; significant difference was observed between them. [F. Ghasemi Sahebi et al. Effect of water stress on potato product in the drip irrigation (T-Tape). International Journal of Agricultural Science, Research and Technology, 2011; 1(2):95-98].

المصادر:

corrugation irrigation methods on the quantitative and

qualitative factors of the potato. agriculture scientific

documents and information center journal, no 121, p

66.

2. Baghani, J., Alizadeh, A. (1376). product

performance and water use efficiency in the drip and

corrugation irrigation methods. agriculture

engineering researches, 5(18): 1-10.

3. Bahrani, B., Javan, M. (1995). Comparison of

overhead and corrugation irrigation methods on

chickpea and potato, Karaj agriculture research

center.

4. Raeesi, F. (1991). Determination of irrigation

water for potato, study report of Esfahan soil and

water research sector, Esfahan agriculture research

center.

5. Madanchi, N., Azari, K., Rahimi, M. (1993).

interaction of water and fertilizer on potato, summary

of soil and water studies on the sugarcane, alfalfa,

potato, and wheat of Hamadan region, organization

of agriculture researches, institute of soil and water

studies.

6. Awari, H. W., Hiwase, S. S. (1994). Effect of

irrigation system on growth and yield of potato,

Annals of Plant Physiology 8(2): 185-187.

7. Gupta, J. P. and Singh, S. D. (1983). Hydrothermal

environment of soil, and vegetable production with

drip and furrow irrigations, Indian J. Agric. Sci.

53(2): 138-142.

8. Shalhevet, J., Shimshi, D. and Meir, T. (1983).

Potato irrigation requirements in a hot climate using

sprinkler and drip methods, Agron. J.75 (1): 13-16.

9. Singh, N., Sood, M. C. (1994). Water and nitrogen

needs of potato under modern irrigation methods, PP.

142-146. In: Shekhawat, G. S., Khurana, S. M. P.,

andey, S. K. and Chandla, V. K. (Eds.), Proceedings

of the National Symposium, Modipuram, India,

Potato: Present and future, Indian potato Association,

Shimla, India.

10. Singhsaggu, S. and Kaushal, M. P. (1991). Fresh

and saline water irrigation through drip and furrow

method, International Journal of Tropical Agriculture

3: 194-202.