کاهش اضافه¬ولتاژ ناشی از کلیدزنی نیروگاه بادی توسط برقگیر
محورهای موضوعی : مهندسی برق- قدرت
1 - گروه برق، واحد کازرون، دانشگاه آزاد اسلامی، کازرون، ايران
کلید واژه: نیروگاه¬های بادی, کلیدزنی, اضافه ولتاژ, برقگیر, نرم¬افزار EMTP-RV,
چکیده مقاله :
به دلیل مشکلات ناشی از سوختهای فسیلی به مانند آلودگی زیست محیطی، تخریب لایه ازن، گرم شدن کره زمین و تغییرات آب و هوایی، استفاده از نیروگاههای تجدیدپذیر مختلف از جمله نیروگاههای بادی در شبکه قدرت روز به روز در حال افزایش است. به دلیل تغییرات زیاد در بار شبکه و همچنین تغییرات سرعت باد، نیروگاههای بادی مرتباً در شبکه کلیدزنی میشوند که این کار توسط کلید خلا انجام میشود. به دلیل کلیدزنی این نیروگاهها در شبکه برق اضافه ولتاژهایی اتفاق میافتد. اصلي ترین عامل ايجاد اضافه ولتاژ در هنگام کليدزني، بحث وصل مجدد کليد در زمان باز شدن کنتاکتها میباشد بطوریکه این اضافه ولتاژها در برخی موارد آنقدر زياد است که شکست عايقي در برخي تجهيزات از جمله توربين بادي، کليدها، مقرهها، تجهيزات حفاظتي، تجهيزات اندازهگيري و کابلها را میتواند به دنبال داشته باشد. بنابراین این اضافه ولتاژها باید مورد بررسی قرار بگیرد. در اين مقاله مدلسازی کلیدها و نیروگاههای بادی در مطالعات حالت گذرای سیستم قدرت مورد بررسی قرار گرفته تا بتوان اثر کلیدزنی این نیروگاهها را که منجر به اضافه ولتاز میگرد مطالعه نمود. سپس با استفاده از برقگیر، اضافه ولتاژ ایجاد شده ناشی از کلیدزنی نیروگاه بادی کاهش داده میشود. به منظور شبیهسازی این اضافه ولتاژها از نرمافزار EMTP-RV که یکی از نرمافزارهای قوی در زمینه تحلیل حالت گذرای سیستم قدرت میباشد استفاده شده است.
Due to the problems associated to the fossil fuel-based power plants, such as pollution production, climate change, global warming and warning about price change, the use of renewable power plants especially wind power plants in the power grid is increasing day by day. Due to large changes in the grid load and also changes in wind speed, wind power plants are regularly switched in the grid, which is done by vacuum switches. Due to the switching of these power plants, overvoltages occur in the power grid. The main factor causing overvoltage during switching is the reconnection of the switch when the contacts open, so that these overvoltages are in some cases so high that they can lead to insulation failure in some equipment including wind turbines, switches, insulators, protective equipment, measuring equipment and cables. Therefore, these overvoltages should be investigated. In this article, the modeling of switches and wind power plants in power system transient studies is examined in order to study the effect of switching these power plants, which leads to overvoltages. Then, using a lightning arrester, the overvoltage caused by the switching of the wind power plant is reduced. In order to simulate these overvoltages, EMTP-RV software, which is one of the powerful software in the field of power system transient analysis, has been used
[1] T. Abdulahovi, “Analysis of High-Frequency Electrical Transients in Off shore Wind Parks”, Licentitate Degree, Department of Energy and Environment, Division of Electric Power Engineering, Chalmers University of Technology, Göteborg, Sweden, 2009.
[2] E. Persson, “Transient effects in application of PWM inverters to induction motors”, IEEE Transactions on Industry Applications, vol. 28, no. 5, pp. 1095-1101, 1992.
[3] S. Wong, L. Snider, and E. Lo, “Overvoltages and reignition behavior of vacuum circuit breaker”, 6th International Conference on advanced in Power system, pp. 653-658, 2003.
[4] P.Picot, “Vacuum Switching”, Cahier technique Schneider Electric, no. 5, p. 4, March 2000.
[5] D. Clare, “Failures of encapsulated transformers for converter winders at Oryx Mine”, Elektron magazine, pp. 24-27, 1991.
[6] A. Mazur, I. Kerszenbaum, J. Frank, “Maximum insulation stresses under transient voltages in the HV barrel-type winding of distribution and power transformers”, IEEE transactions on industry applications, vol. 24, no. 3, pp. 427-433, 1988.
[7] M. Olsen, “Failure analysis of siemens geafol cast-resin transformer”, Danish Tech. Inst., Tech. rep, pp. 1154834-1, 2003.
[8] D. Paul, “Failure analysis of dry-type power transformer”, IEEE Transactions on Industry Applications, vol. 37, no. 3, pp. 689-695, 2001.
[9] D. D. Shipp, T. J. Dionise, V. Lorch, and B. G. MacFarlane, “Transformer failure due to circuit-breaker-induced switching transients”, IEEE transactions on industry applications, vol. 47, no. 2, pp. 707-718, 2011.
[10] M. Glinkowski, “Electrical Environment of Transformers; Impact of fast transients”, Electra, pp.25-38, February 2005.
[11] W. H. Bartley, “An Analysis of Transformer Failures, Part 2–Causes, Prevention and Maximum Service Life”, Hartford, CT, 1997.
[12] B. Gupta, B. Lloyd, D. Sharma, “Degradation of turn insulation in motor coils under repetitive surges”, IEEE transactions on energy conversion, vol. 5, no. 2, pp. 320-326, 1990.
[13] G. Stone, R. Van Heeswijk, R. Bartnikas, “Investigation of the effect of repetitive voltage surges on epoxy insulation”, IEEE Transactions on energy conversion, vol. 7, no. 4, pp. 754-760, 1992.
[14] J. H. Larsen, H. C. Soerensen, E. Christiansen, S. Naef, P. Vølund, “Experiences from Middelgrunden 40 MW offshore wind farm”, in Copenhagen offshore wind conference, pp.1-8. 2005
[15] W. Sweet, “Danish wind turbines take unfortunate turn”, IEEE Spectrum, vol. 41, no. 11, pp. 30, 2004.
[16] B. Gupta, B. Lloyd, G. Stone, S. Campbell, D. Sharma, N. Nilsson, “Turn insulation capability of large ac motors part 1-surge monitoring”, IEEE transactions on energy conversion, no. 4, pp. 658-665, 1987.
[17] B. Gupta, N. Nilsson, and D. Sharma, “Protection of motors against high voltage switching surges”, IEEE transactions on energy conversion, vol. 7, no. 1, pp. 139-147, 1992.
[18] J. He, et al. “Transient Equivalent Modelling of a Wind Farm Based on QPSO-Based Wind Turbine Fault Ride-Through Control”, Energies, Vol. 18, no. 5, 19961073, 2025.
[19] L. Jiang, et al, “Numerical and experimental analysis of the lightning transient behavior of electric heating deicing control system of wind turbine blade”, Electric Power Systems Research, Vol. 241, 111385, 2025.
[20] X. Tian, et al. “Analytical Analysis of Mechanism and Mitigation Methods of Transient Overvoltage in Direct-Drive Wind Turbine Generators Connected to Weak Power System”, IEEE Access, 2025.