Effects of Tool Tilt Angle and Plunge Depth on Properties of Polycarbonate FSW Joint

Subject Areas :

Hamidreza Mohammadi Kuhbanani ¹ (Shahid Dadbin Technical and Vocational University, Kerman, Iran)
Hesameddin Yasemi ² (Shahid Dadbin Technical and Vocational University, Kerman, Iran)
Hamed Aghajani Derazkola ³ (Young Researchers and Elites Club, Science and Research Branch, Islamic Azad University, Tehran, Iran)

Received: 2019-08-08 Accepted : 2019-11-03 Published : 2018-11-01

Keywords: Mechanical Properties, PC, Friction Stir Welding, Computational Fluid Dynamics,

Abstract :

In the present article, the effects of friction stir welding (FSW) tool plunge depth (TPD) and tool tiltangle (TTA) were investigated on the heat generation and the material flow during solid-statejoining of polycarbonate (PC) sheet experimentally and simulated with computational fluiddynamics (CFD) method. Simulation results showed that increasing heat input (higher TTA andlower TPD) could increase the size of the stir zone. Results indicate that control of TPD and TTAcan improve the material flow near the top surface. The temperature field in the friction stir weldingof PC was anti symmetric to the welding line. Due to the results, the heat generation andtemperature distribution at the advancing side were more than the retreating side in all jointconditions. According to selected parameters, a strong sample was produced at 1.2 TPD and 2.5oTTA. This sample had 92% PC tensile strength, 89% PC flexural strength, and 86% of impactenergy.