A Survey to Monolithic Microwave Integrated Circuit Design Technology

Subject Areas : Majlesi Journal of Telecommunication Devices

Amir Hossein Mozafari ¹ (Department of Electrical Engineering, Islamic Azad University, Majlesi Branch, Esfahan, Iran)
Behzad BahramiNejad ² (Department of Electrical Engineering, Islamic Azad University, Majlesi Branch, Esfahan, Iran)

Received: 2014-02-12 Accepted : 2014-02-12 Published : 2014-06-01

Keywords: en,

Abstract :

The design of MMICs is essentially the same as that for most microwave components: one or more signals must be coupled onto the chip efficiently, then functions are performed on the signals, after which they are then coupled out of the chip and back into the system. the efficient coupling of signal power requires that the impedance of the signal source match that of the chip. In fact, to pass the signal efficiently through the whole chip, the impedances of the transmission lines, the active devices, and the system it sits in must all be matched. MMIC design is founded on impedance matching and control across the frequency range of interest. Gain and Noise Figure of a typical transistor is decreased and increased in terms of frequency increase, respectively.

References:

[1] Uyeda, J., et al., “0.1 μm InP HEMT MMIC Fabrication on 100 mm Wafers for Low Cost, High Performance Millimeter-Wave Applications,” Proc. GaAs MANTECH Conference, Miami Beach, FL, May 3–5, 2004.

[2] Milligan, J. W., et al., “Transition of SiC MESFET Technology from Discrete Transistors to High Performance MMIC Technology,” Proc. GaAs MANTECH Conference, Miami Beach, FL, May 3–5, 2004.

[3] Kikkawa, T., et al., “An Over 200-W Output Power GaN HEMT Push-Pull Amplifier with High Reliability,” Proc. IEEE Microwave Theory Tech. Symposium, Forth Worth, TX, June 6–11, 2004.

[4] http://www.triquint.com/prodserv/divisions/foundry/docs/HFET.pdf.

[5] http://www.research.ibm.com/DAMOCLES/html_files/hfet.html.

[6] L., Devlin, S., Glynn, Gr., Pearson and A., Dearn, “The Design of E-band MMIC Amplifiers”,August, 2010.

[7] E C., Niehenke, F., Robert A. Pucel, Life Fellow, and I J., Bahl, Fellow, “Microwave and Millimeter-Wave Integrated Circuits”, IEEE TRANSACTIONS ON MICROWAVE THEORY AND TECHNIQUES, Vol. 50, No. 3, March 2002.