The Effect of Heat Treatment on the Structure of PEO Coating on Ti-6Al-4V Alloy

Subject Areas : Journal of Environmental Friendly Materials

M Garshasbi ¹ , A Shokuhfar ² , M Ghanbari Haghighi ³ , B Karbakhsh ⁴

1 - Department of Materials Engineering, Karaj Branch ,Islamic Azad University, Karaj, Iran
2 - Department of Materials Engineering, K.N.Toosi University of Technology, Tehran, Iran
3 - Department of Materials Engineering, Karaj Branch ,Islamic Azad University, Karaj, Iran
4 - Department of Materials Engineering, Karaj Branch ,Islamic Azad University, Karaj, Iran

Received: 2020-01-17 Accepted : 2020-03-27 Published : 2020-06-01

Keywords:

Abstract :

In order to increase the corrosion resistance and improve the biocompatibility of Ti-6Al-4V alloy used in medical applications such as implants, it has been modified with various methods including PEO. On the other hand, this alloy is also capable of heat treatment. In this study, firstly different structures were obtained by heat treatment of Ti-6Al-4V substrate and then different structures were coated with the same parameters, by PEO method. The scanning electron microscope equipped with EDS was used to investigate the morphology and cross-sectional of ​​the coatings. X-ray diffraction was also applied to analyze the phases created in the coating. Additionally, investigation of surface topography was performed by atomic force microscopy. Results have represented that the martensitic structure has a lower porosity with more regular dispersion. The creation of coating with martensitic structure also shows good thickness with high quality smoothness. On the other hand, the coating of the α-plate and inter-grain β structure were included large and irregular porosities.

References:

[1] R. Pederson, “Microstructure and phase transformation of Ti-6AL-4V”, Licentiate Thesis, Lulea University, (2002), 2.

[2] M. Roknian, A. Fattah-Alhosseini, S. O. Gasht, K. M. Keshavarz, J. Alloys Compd, 740, (2018), 330.

[3] J. I. Kang, M. K. Son, H. C. Choe, W. A. Brantley, Thin Solid Films, 620, (2016), 126.

[4] E. Urbanczyk, A. Krzakala, A. Kazek.Kesik, J. Michalska, Surf. Coat. Technol., 291, (2016), 80.

[5] M. Montazeri, C. Dehghanian, A. Baradaran Goorani, J. New Mater., 1, (2010), 7.

[6] Y. L. Cheng, X. Q. WU, Z. G. Xue, E. Ina Matyk, P. Skeldon, G. E. Thompson, Surf. Coat. Technol., 217, (2013), 129.